|
|
Engine Compartment
Accelerator linkage at firewall rebuild kit, includes 2 firewall rod rubber bushing, 1 steel/rubber bushing for engine compartment actuator rod, and 1 ball end bolt, twin carburetor models only
|
Accelerator linkage bolt with ball on one end.
|
Accelerator rod from firewall to bell crank. For carburetored cars only.
|
Brake Caliper kit, rear. Does both calipers
|
Bushing, rubber one on accelerator actuator shaft/rod on firewall, carb models only, rounded head bolt goes through it, attaches to throttle actuator rod.
|
Clutch hose, new manufacture, very high quality
|
Differential limited-slip assembly, complete, new manufacture, specify coarse or fine spline shafts and diameter at spline end, more robust than 2000 c.c. version, designed to fit 1300, 1600, 1750 and 2000 c.c. differential housing.
|
Driveshaft rubber donut, flex coupling.
|
Engine gasket set, complete, very high quality, asbestos-free modern, high-tech materials. 2000 c.c., silk-screened sealant on the large gaskets.
|
Engine gasket set, very high quality style gaskets, silk-screened style sealant wherever applicable, includes crankshaft seals front and rear, perfect for either 1750 or 2000 engines. Order the appropriate head gasket separately to match this set.
|
Engine, short stroke, used 1357 cc, 80mm X 67.5mm with head, block, crank, alternator, water pump, less carbs. Used for 9000 RPM racing motor.
|
Engine, Twin-spark, 2000 cc, good used motor from a running car in Italy, includes the F.I. airflow meter, alternator, and starter.
|
Exhaust gaskets, from header to manifold, copper
|
Fan blade, high performance, Euro style, requires less HP to turn, 6 blade, white plastic
|
Firewall grommet, heater hose.
|
Gas tank sending unit gasket, fits Marelli, Veglia and Jaeger gas tank sending units with six screw mount, this is gasket only.
|
Head gasket, very high quality, modern style with silk-screened sealant around perimeter, 2000 c.c. engines only
|
Oil filter, fuel injection pump, SPICA, new manufacture, with spring and attached O ring rubber gasket ***Not correct for Montreal***
|
Oil pump gears, 9 tooth, 1 brass, 1 steel, NOS.
|
Radiator by-pass hose, please verify outside diameter of hose and approximate length..
|
Radiator cap, two ear style, instructions on top in Italian and English, 0.7ATM
|
Radiator hose, lower, original style with patterned surface. Verify diameter of hose ends when ordering.
|
Radiator hose, upper, new manufacture by OEM supplier, old style with textured surface, 105023190800, for 1300-1600 only, please verify outside diameter of intake manifold and radiator.
|
Radiator hose, upper,original style with patterned surface 10557318010000. Check diameter of hose ends when ordering.
|
Ring & pinion, 5:12 ratio, 8/41, new manufacture for Re-Originals, from Italy. For any application with 2 liter differential.
|
Spark plug wire set, OEM, gold core black wires with correct, original resistors throughout, Valid for 2000 c.c. Alfa Spider 87-92. Non-radio cars only.
|
Spark Plug wire set, original red Cavis wire style. With coil cover cap and distributor shell cover boot, for radio equipped cars.
|
Synchronizer rings, original yellow dot style, Goertze
|
Syncro. slider rings, NOS, split-case transmission.
|
Tailpipe and rear resonator, performance version by Ansa.
|
|
|