|
|
Upholstery
Binding for carpet, black, stipple grain, 40mm wide x 40 mt. long, equivalent to 1 running meter.
|
Binding, original dark gray trim material, stipple grain, 40 mm wide x 40 mt. long, equals one running meter.
|
Bumperette to bumper gasket.
|
Carpet saver, specify with or without alfa emblem. Specify car and color. Priced per driver and passenger side.
|
Carpet set for trunk to replace original rubber mats. Black synthetic wool with Jute backing. Covers entire inside of trunk, floor, taillight area, inner fender wells, back of rear seat bulkhead. Call for photo or look on web-site.
|
Carpet Set, Custom made carpet set using 100% Italian wool with jute backing, black, red, light grey, or beige with correct binding. Specify with or without pedals mounted in floor.
|
Carpet set: Custom-made carpet using original style Italian synthetic wool with jute backing, the old style dark gray anthracite gray with salt & pepper flecks. Specific fit for the 1969 GTV 1750with floor mounted pedals only
|
Carpet set: Custom-made carpet using original style Italian synthetic wool with jute backing, the old style dark gray anthracite gray with salt & pepper flecks or any other color. Specific fit for the 1969 GTV 1750, Series II with dash mounted pedals onl
|
Carpet, original Italian anthracite (salt & pepper) synthetic wool, jute back, short pile, 2 mt. wide
|
Dashboard vinyl, requires vacuum/heat system to install.
|
Door panel boards only, these will fit any GTV perfectly from 1964 through 1969. The exact vinyl is available separately.
|
Door Panels: 2nd Series 1750, style that uses 1 horizontal chromed plastic strip near bottom, with correct heat-stitched ribs below plastic strip near bottom and vertical ribs at rear, made on original dies, tan (#20093).
|
Door Panels: 2nd Series 1750, style that uses 1 horizontal chromed plastic strip near bottom, with correct heat-stitched ribs below plastic strip near bottom and vertical ribs at rear, made on original dies, black (#20009).
|
Door Panels: All 1600s, 1st Series 1750, and some 1300 Jr.s, style that uses 2 horizontal stainless steel trim pieces, pre-drilled holes to fit your original trim pieces, tan (#20093).
|
Door Panels: All 1600s, 1st series 1750, and some 1300 Jr.s, style that uses 2 horizontal stainless steel trim pieces, black (#20009).
|
Gear shift lever boot, black leather, circular heat-stitched pattern at top exit hole for lever, 4 panels sewn together
|
Gear shift lever boot, black vinyl, circular heat-stitched pattern at top exit hole for lever, 4 panels sewn together
|
Hand-brake boot, black leather
|
Hand-brake boot, black vinyl
|
Headliner kits: correct pre-sewn bow-hooped headliner with pre-sewn C-Pillar legs, uses original #20031, includes non-perforated piece for area in roof over rear seat.
|
Headliner, original bone headliner insert vinyl, leather grain, 1.4 mt. (56) wide.
|
Headliner, original ivory snakebite pattern vinyl, 1.4 mt. (56) wide
|
Seat bottom cover only for rear seat. Black original vinyl, one of two parts, Series 1 only.
|
Seat bottom or seat back cover for rear seat, original vinyl, one of two parts, series 2 only.
|
Seat cover, front, only one cover with one headrest, Series 2 only, original vinyl, exact match.
|
Seat cover, front. Series 1 only, original vinyl, style with 1 large headrest on passenger side only, black.
|
Seat cover, rear, complete, original vinyl, exact match.
|
Seat cover, rear, complete, series 1 only, pig-skin color vinyl.
|
Seat covers, front only, complete pair with headrests, Series 2, specify original color, exact match, made in Italy.
|
Seat covers, front, only, both covers, includes headrests, specify 1 single headrest in passenger seat only, or 2 small headrests - one on top of each seat. Series 1 only. Available in 4 original colors of smooth Italian vinyl with exactly correct baske
|
|
|