|
|
Engine Compartment
Springs, coil for front and rear suspension kit, on all Giulietta based cars. Modern manufacture, standard configuration.
|
Steering column firewall grommet, for column shift cars only, has bellows attached for column shift rod.
|
Swaybar link bushings, front, modern material, looks like the old material, 4 required per car, mount on outside link, look like half-globes
|
Syncro ring sliders, 750 only, tunnel case, NOS
|
Syncro ring, 101, split case transmission, style with concentric groove around syncro, generally 1600 only
|
Syncro rings, 750, tunnel case transmission, bronze style with teeth, set of 4, 2 small and 2 large.
|
Syncro rings, large style, tunnel-case transmission only.
|
Syncro rings, small style, tunnel-case transmission only.
|
Throttle link end, goes at the end of accelerator rod.
|
Throw-out bearing for a clutch, specify original style with carbon face or modern version with hardened steel face, Teflon surface
|
Thrust washers for engine, specify standard or oversize
|
Tie rod end boots, small size
|
Tie rod ends, NOS, external thread, specify left or right hand thread and diameter of thread, includes installed Zerk fitting. These are the exact, old original style
|
Tie rod ends, outer, NOS, internal thread, specify left or right hand thread and diameter of thread, includes installed Zerk fitting. These are the exact, old original style
|
Transmission gasket and seal kit, includes two paper gaskets for tunnel case transmission, front and rear seals, for tunnel case transmission only
|
Transmission mount, original style, new manufacture, 750, tunnelcase transmission only
|
Upper suspension rebuild kit, NOS, complete with new A arm supports, bushings, seals, brass washers, and nuts; kit is for both sides. Specify if A arm supports stand alone or are connected. Verify the diameter of bolts that pass through chassis to hold
|
Valve adjusting shims, 8mm, for 750 motors and GTA.
|
Valve cover gaskets, Giulietta cars, 1st series. (750) These are narrower than the 101 series.
|
Valve cover nuts with black Bakelite outer ring, Alfa Romeo script as original, new manufacture, uses 14mm hex wrench, Giulietta 1300 & Giulia 1600 only
|
Valve cover nuts, Veloce only, chromed thin, serrated edge, no Bakelite border on Veloce models, includes gasket and retaining clip
|
Valve guide, 8mm stem, 750 only.
|
Valve springs, complete set of 16 pieces, specify diameter specify diameter and if for a Veloce or not
|
Valves, exhaust, 8mm stem, 750 only
|
Valves, intake, new manufacture, 8mm stem, 750 only
|
Water thermostat, original in-line style, goes in radiator hose, 750 engines only, verify inside diameter of attaching hoses
|
Wheel slave cylinder, new manufacture, rear, this is a complete cylinder.
|
Windshield wiper splined post mechanism for windshield wiper mechanism that clamps onto a coiled wire and is driven by it through a mating gear.
|
Wiring harness for Sprints.
| |
|
|