|
Engine Compartment
Master cylinder gland nut for the end of the cylinder. Specify whether or not with a threaded hole for the stop light switch or without the hole.
|
Master cylinder rebuild kit for all drum brake cars.
|
Master cylinder, new manufacture. These are quite nice.
|
Motor mount bumper rubber, mounts on left side motor mount, or chassis-mounted bracket near left side motor mount, Veloce motors only
|
Motor mount, 1300 Only, rubber, new manufacture, correct style, has modern updated nut inside one end instead of stud; makes installation of engine much easier.
|
Motor mount, aluminum base only, new production, right side, Veloce only
|
Motor mount, aluminum base only, original, left side, specify with or without rubber bumper foot, Veloce only.
|
|
Oil filter assembly. Fispa Foill, 1315-59704, NOS, complete.
|
Oil pressure flex line, new manufacture, wire mesh covered hose, specify if S shaped fitting on engine end or straight-out fitting.
|
Oil pump, new manufacture, high capacity, 9 tooth gears, racing or street style that uses removable oil pick-up foot, or extension. For 1300 cc cars only.
|
Oil temperature sending unit, NOS, spade terminal connection
|
Point set, Lucas, Giulietta 1300 only, 1315554114
|
Points for Marelli distributor S-73A only, Veloce only for Sprint and Spider
|
Radiator cap, two ear style, instructions on top in Italian and English, 0.7ATM
|
Radiator hose, lower, 1365.88.402, for all Giulietta Sprints, please verify outside diameter of intake manifold and radiator.
|
Radiator hose, lower, specify Sprint or Sprint Veloce, verify outer diameter of water pump and radiator necks.
|
Radiator hose, upper, small part between the thermostat and the manifold, length 60mm, #1365.88.414, for Veloce only generally, but not always. Please specify outside diameter of intake manifold and radiator.
|
Radiator hose, upper, with thermostat in manifold, 1365.88.419, Giulietta Sprint, TI, and Berlina.
|
Radiator hose, upper. Goes between radiator and inline thermostat. 195mm long, 40mm diameter and 30mm diameter ends.
|
Radiator supports. One rubber ring that fits on top of another rubber section that has a central projection.
|
Relay for horn or lights, NOS, DeLeon, as originally mounted
|
Ring & pinion, 5:12 ratio 8/41, NOS,185mm OD, 104mm ID, 8 bolt, 130mm pattern, great for 1300, 1600, 1750 differentials, go faster immediately, cheaply.
|
Rotor arm for Lucas distributors, p.n.40052, distributors p.n. 40431,40649, Giulietta 1300 only
|
Rotor for Marelli distributor. S-73A or S-71B
|
Shock absorber, front, specifically for Alfa Giulietta Veloce Sprint and Spider, SS and SZ 1300. 101.06.21.070.00
|
Shock absorbers, front for Alfa Giulietta and Giulia Spiders and Sprints, 750 & 101. New Koni Classic line
|
Shock absorbers,rear, for Alfa Giulietta and Giulia Spiders and Sprints, 750 & 101. New Koni Classic line
|
Spark plug wire set, original Cavis green 5mm solid wire style, includes spark plug boots, short coil lead, & boots for distributor cap, OEM #2151
|
Spring perch rubber cushion for coil springs on Giulietta cars. Specify diameter and thickness desired.
|
|
|