|
|
Engine Compartment
Exhaust pipes and muffler. Front pipes that connect to the header with a single Siamese flange, then attaches to a small muffler just under the floor. A short section of pipe afterwards that would hook up to the tailpipe and muffler unit. Made in Italy
|
Ferrels, 8mm, yellow wire-wound fuel line or carburetor hose
|
Flasher, Lucas, for turn signal switch, correct for most all Alfas.
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, FISPA, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, Tecnocar, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter element with new spring, twin carb models
|
Fuel pump diaphragms, for Fispa SUP 60 head mounted fuel pumps.
|
Fuel pump support for electric pumps at rear of car, rubber mount with 1 stud on each end, Veloce only, barrel shaped.
|
Fuel pump support for electric pumps at rear of car, rubber mount with 1 stud on each end, Veloce only, hourglass shape with hexagonal ends.
|
Fuel pump support for electric pumps at rear of car, rubber mount with 1 stud on each end, Veloce only, hourglass shape.
|
Fuel pump, eclectic, vintage Bendix style, cylindrical fuel pump as used in the 50s and 60s. High volume, 4.5 PSI, 45 gal per hour. Generally for racing applications only.
|
Fuel pump, electric,vintage Bendix style, cylindrical fuel pump as used in the 50s and 60s. Low pressure style for multiple carburetors. 3 PSI, 30 gal per hour.
|
|
|
Gas tank sending unit gasket, fits Marelli, Veglia and Jaeger gas tank sending units with six screw mount, this is gasket only.
|
Gas tank sending unit, new manufacture, Veglia
|
Gear shift cable for column mounted shift levers, Sprint only
|
Gear shift lever, for column shift, NOS, Sprint 1st series
|
Gear, front of crankshaft, drives oil pump
|
Head gasket, original Elring or modern manufacture using Reintz material, 750 1300 engine only
|
Head gasket, very high quality, modern style with silk-screened sealant around the perimeter, Rientz material, 1300 101 cars only
|
Heater valve diaphragm, for style with star-shaped knob
|
Heater valve, 5 point star knob style, new manufacture
|
Hose clamp for fresh air hose, or carb plenum to air filter, 2 pieces, includes pre-formed strap and spring clasp, for round or oval hose 3 diameter or larger
|
Hose clamp for radiator, old style solid strap with large cotter-pin style head, 9mm wide strap
|
Hose clamp strapping 5 mm (sold per foot )
|
Hose Clamp strapping 9 mm for fuel lline (sold by the foot )
|
Hose, 32mm, for defroster under dash, the original stuff, reinforced foil, paper covering, black accordion surface
|
Ignition points, Lucas, NOS, 1315.55.402/9
|
Ignition set, Bosch Plex, distributor without points, special coil, special spark plug wires.This set fits all 4 cylinder cars with positive ground systems.
|
Lower suspension rebuild kit, NOS, complete with new A arm supports, bushings, seals, brass washers, and nuts; kit is for both sides. Specify diameter of bolts that pass through chassis.
|
|
|