|
Engine Compartment
Syncro ring, 101, split case transmission, style with concentric groove around syncro, generally 1600 only
|
Syncro rings, 750, tunnel case transmission, bronze style with teeth, set of 4, 2 small and 2 large.
|
Syncro. slider rings, NOS, split-case transmission.
|
Thermostat, for single carb. cars only. The outside diameter is 54mm.
|
Throttle link end, goes at the end of accelerator rod.
|
Thrust washers for engine, specify standard or oversize
|
Tie rod end boots, small size
|
Tie rod ends, NOS, external thread, specify left or right hand thread and diameter of thread, includes installed Zerk fitting. These are the exact, old original style
|
Tie rod ends, outer, NOS, internal thread, specify left or right hand thread and diameter of thread, includes installed Zerk fitting. These are the exact, old original style
|
Transmission mount, original style, new manufacture, 750, tunnelcase transmission only
|
Upper suspension rebuild kit, NOS, complete with new A arm supports, bushings, seals, brass washers, and nuts; kit is for both sides. Specify if A arm supports stand alone or are connected. Verify the diameter of bolts that pass through chassis to hold
|
Valve adjusting shims, 8mm, for 750 motors and GTA.
|
Valve cover gaskets, Giulietta cars, 1st series. (750) These are narrower than the 101 series.
|
Valve cover gaskets, Giulietta cars, 2nd series. For 101 series.
|
Valve cover nuts with black Bakelite outer ring, Alfa Romeo script as original, new manufacture, uses 14mm hex wrench, Giulietta 1300 & Giulia 1600 only
|
Valve cover nuts, Veloce only, chromed thin, serrated edge, no Bakelite border on Veloce models, includes gasket and retaining clip
|
Valve guide, 8mm stem, 750 only.
|
|
Water pump, 750/1300 only, new manufacture water pump has a threaded end on the shaft to attach the pulley
|
Wheel slave cylinder, new manufacture, rear, this is a complete cylinder.
|
Wiring harness for Sprints.
|
|
|