Next     Previous     Home

Ferrari 330 SWB Cal Spider

Project

   1964 Cal Spyder #6515 was built from a 330 GT 2+2 4 headlight car. Originally owned 

   by Tom Shaughnessy. Then purchased by Rich Jackson in Philadelphia. Norwood Autocraft

   began the  conversion to a Spyder SWB by installing it in their frame jig and shortening it. 

   The chassis was subsequently painted with Black Epoxy. Somewhat after that time Rich

   Jackson borrowed money against the car from pledge cap in New Jersey. They picked 

   up the car in 7/17/18 approximately a year later the car was shipped back to Norwood

   Autocraft to be assembled. Norwood Autocraft rebuilt the engine and transmission,

   went through the rear end and installed it in the chassis.

   Norwood Autocraft also installed the rear brakes, calipers and emergency brake system.

   The car was then shipped to the body shop to have the body fabricated. Work was 

   stopped in 2020 when Covid started and the project was never finished. The car 

  comes with a copy of the old Minnesota title and the shim chart from the front

  end rebuild. Car now has a New York registration.

  *Engine – The 330 engine was completely rebuilt with .003 overbore, JE Pistons and

  rings, crankshaft standard, new bearings installed, cylinder heads rebuilt, oversized

  valves were installed to get the valves back up on the seats. Engine has distributor 

  drives and tach odometer drive, throttle linkage for all three carbs, a new air cleaner

   and elements. The correct alternator mount and arm. Headers, heat  shield covers,

  new downpipes, original mufflers, cover for the fuel pump, new stainless steel gas

   tank, flywheel clutch disk and cover, transmission is rebuilt and modified to

   remove the overdrive, driveshaft is included, foot box and pedals are installed, steering

  box and all steering rods, steering shaft, upper steering shaft, new carrier and bearings,

   remote filter, front engine fan restored, front engine fan mount, correct Borrani

   wheels, rebuilt knockoffs 

  *Body - left and right window lifts, complete top mechanisms and mounts. Rear top catches,

  new taillights lenses, original bases, headlight buckets, driving lights, parking lights, one seat

  frame and seat track, original heater and remote fan, original 250 wiring harness, battery box,

  plastic mount plate, windshield post and all hardware, levers for the top latches, original horn set

  (disassembled), floors are installed, front brakes and rotors, hood and deck latches, side trim and jack

  plugs, wiper motor, Fiberglass dash is included. The car will be furnished with the doors and body

  mounted on a temporary basis for shipping. 

 

  

  

                     

 

                                                                                                                                                                           

 

Many other small, important aluminum body parts are included.