|
Engine Compartment
Accelerator linkage bolt with ball on one end.
|
Accelerator rod from firewall to bell crank. For carburetored cars only.
|
Air Hose between plenum and air filter, on either side of tube that goes across valve cover, rubber tube, covered in canvas wire winding except on ends.
|
Axle support bumper for Alfa 2600 Spider, NOS
|
Ball joint boots, lower, large size
|
Ball joint boots, upper, medium size
|
Bearings, main, specify standard or which oversized desired, 2600 only
|
Bearings, rod, specify standard or which oversized desired., 2600 only
|
Boot for 5mm spark plug cable connection to distributor caps
|
Boot for 5mm spark plug cable to spark plug connectors.
|
Brake hose, front, original style, new manufacture, #1365.64.019, for all Giulietta Spider, and for Giulietta Sprint only after chassis number 0200 (before this number E0141X was used), also valid for 2600 Touring Spider. 3/8 X 24, length of threaded por
|
Brake hose, rear, from body to differential, #1365.64.020 for Giulietta-based cars, also clutch hose for 2600 Touring. 3/8 X 24, long threaded portion is 29/32, short threaded portion is 7/16, overall length is 14 15/16. Verify these dimensions please.
|
Brake hose, rear, from body to differential, #1356.88004, for chassis #1493.00001 to #1493.00200 on G. Sprint, valid for all 1900 models and the 2000 and 2600 Touring. 7/16 X 20, long threaded portion is 29/32, short threaded portion is 7/16, overall le
|
Brake lining. NOS. Front or rear, 4 pieces per set. Specify length and width and spacing between rivets to verify fit. These are the original ones, not a re-manufacture
|
Brake reservoir, NOS, Girling, 2 hose fitting on bottom style.
|
|
|
|
Carburetor rebuild kits, three included, for Solex 44PHH carbs, 2600 only
|
Carburetor rubber spacer mounts for carbs, new manufacture, three left and three right
|
Clutch cover, NOS, 2600 only
|
Clutch cover, rebuilt for 2600 only
|
|
Clutch Master Cylinder, new manufacture, 102001205100
|
Clutch slave cylinder, New, Alfa part number102.00.12.050.00
|
Clutch throw-out bearing, NOS, 2600 only. 72mm OD x 45mm ID x 14.5mm width
|
Connector, brass for 5mm spark plug wire to spark plug.
|
Crankshaft seals, front and rear, new manufacture, very high quality, 2600 only
|
Differential support bushings, verify dimensions to check fit.
|
Distributor Cap, Bosch 2600 only
|
|
|