|
Engine Compartment
Carburetor rubber spacer mounts, very high quality, new manufacture, for Weber DCOE carbs or 40mm Dellorto carbs take DCOE style, made by Pirelli.
|
Carburetor rubber spacer mounts, very high quality new manufacture for 45 DCOE
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, with unleaded fuel valve seats and valve guides. Intake bore is for 1600 GTA, can be machined for GTA Jr. or to your specifications. Specify style of valve guide desired an
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, without valve guides or valve seats, with intake bore unmachined so you can custom fit.
|
Differential limited-slip assembly, complete, new manufacture, specify coarse or fine spline shafts and diameter at spline end, more robust than 2000 c.c. version, designed to fit 1300, 1600, 1750 and 2000 c.c. differential housing.
|
Differential support bushings, verify dimensions to check fit.
|
Distributor points, Marelli, some cars require one set, some require two.
|
Engine, Twin-spark, 2000 cc, good used motor from a running car in Italy, includes the F.I. airflow meter, alternator, and starter.
|
Fuel filter element with new spring, twin carb models
|
Hand brake cable, Includes front section that attaches to hand brake handle with correct fittings on each end. Also the rear section that connects to each brake.
|
Head gasket, very high quality, modern style with silk-screened sealant around the perimeter, Reinz material , 1600 c.c. engines only
|
Hose for air filter, oval, black, new manufacture
|
Hose for air filter, oval, bronze color, NOS
|
Radiator cap, two ear style, instructions on top in Italian and English, 0.7ATM
|
Ring & pinion, 5:12 ratio 8/41, NOS,185mm OD, 104mm ID, 8 bolt, 130mm pattern, great for 1300, 1600, 1750 differentials, go faster immediately, cheaply.
|
Ring & pinion, 5:12 ratio, 8/41, new manufacture for Re-Originals, from Italy. For any application with 2 liter differential.
|
Syncro. slider rings, NOS, split-case transmission.
|
Throw-out bearing for a clutch, specify original style with carbon face or modern version with hardened steel face, Teflon surface
|
|
|