|
Engine Compartment
Distributor cap, NOS, specify 1600 or 1300 (GTA only) and method rotor uses to make contact
|
Distributor points, 3 spring short lead.
|
Distributor points, NOS, Marelli, long lead, 3 spring style
|
Distributor rotor, NOS, Marelli, H710833-01, style with center brass contact and off-set carbon brush that points up, GTA Junior models only
|
Driveshaft center support rubber, D shaped.
|
Engine, short stroke, used 1357 cc, 80mm X 67.5mm with head, block, crank, alternator, water pump, less carbs. Used for 9000 RPM racing motor.
|
Engine, Twin-spark, 2000 cc, good used motor from a running car in Italy, includes the F.I. airflow meter, alternator, and starter.
|
Exhaust pipes and mufflers. The entire system after the headers up to the tailpipe. Includes the small front muffler and the large rear muffler. Exact style as original, but heavier duty.
|
Exhaust side pipe racing style. Front section of two piece racing style exhaust as original.
|
Exhaust side pipe racing style. Rear section of two piece racing style exhaust. Exits under the left door and is really, really loud.
|
Fan blade, high performance, Euro style, requires less HP to turn, 6 blade, white plastic
|
Firewall grommet, heater hose.
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, FISPA, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, Tecnocar, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter element with new spring, twin carb models
|
Fuel pump, eclectic, vintage Bendix style, cylindrical fuel pump as used in the 50s and 60s. High volume, 4.5 PSI, 45 gal per hour. Generally for racing applications only.
|
Fuel pump, electric,vintage Bendix style, cylindrical fuel pump as used in the 50s and 60s. Low pressure style for multiple carburetors. 3 PSI, 30 gal per hour.
|
Gas tank sending unit gasket, fits Marelli, Veglia and Jaeger gas tank sending units with six screw mount, this is gasket only.
|
Gas tank sending unit, OEM, specify Veglia or Jaeger, must match the gauge, specify the length of tube from mount flange to tip, modern manufacture
|
Gasket for fuel injection pump, oil filter, fits all Spica 4 cylinder pump body oil filter housings
|
Gear, front of crankshaft, drives oil pump
|
Ground strap for battery, original wire style, covered with black sleeve, lead terminal end
|
Hand brake cable, Includes front section that attaches to hand brake handle with correct fittings on each end. Also the rear section that connects to each brake.
|
Head gasket, very high quality, modern style with silk-screened sealant around the perimeter, Reinz material , 1600 c.c. engines only
|
Headers for exhaust, tube style like the original. The flanges are heavier duty than the original, 1600 only.
|
Hood hinge bumper, stops hinge movement when hood is raised.
|
Hose clamp for fresh air hose, or carb plenum to air filter, 2 pieces, includes pre-formed strap and spring clasp, for round or oval hose 3 diameter or larger
|
Hose clamp for radiator, old style solid strap with large cotter-pin style head, 9mm wide strap
|
Hose Clamp strapping 9 mm for fuel lline (sold by the foot )
|
Hose for air filter, oval, black, new manufacture
|
|
|