|
Engine Compartment
A-arm, adjustable, upper. A terrific way to adjust a non-adjustable front end geometry. Super for alignment on cars previously in an accident.
|
Accelerator linkage at firewall rebuild kit, includes 2 firewall rod rubber bushing, 1 steel/rubber bushing for engine compartment actuator rod, and 1 ball end bolt, twin carburetor models only
|
Accelerator linkage bolt with ball on one end.
|
Accelerator rod from firewall to bell crank. For carburetored cars only.
|
Battery cable, negative, as original, 250mm long, correct Italian battery connection, for cars with engine mounted batteries. Specify diameter of cable desired.
|
Battery cable, positive, as original, 1.4 mt. long, correct Italian battery connection, specify with or without smaller red wire for alternator, for cars with engine mounted batteries.
|
Boot for 5mm spark plug cable connection to distributor caps
|
Boot for 5mm spark plug cable to spark plug connectors.
|
Brake light switch, 105 cars
|
List: $100.00
Price: $93.45
You Save: $6.55 (7 %)
Brake reservoir, new manufacture, round plastic style with metal union at bottom
|
Brake reservoir, NOS, round plastic style with metal union at bottom
|
Bump stop, upper, rectangular shape, flat surface.105.00/41.21.527.00
|
Bushing, rubber one on accelerator actuator shaft/rod on firewall, carb models only, rounded head bolt goes through it, attaches to throttle actuator rod.
|
Carburetor mounts, double style, new OEM manufacturer, factory update, links 1st and 2nd carbs together with a common base, 40mm bore only
|
Carburetor rebuild kit, Weber 40 DCOE, services 2 carbs
|
Carburetor rubber spacer mounts, very high quality, new manufacture, for Weber DCOE carbs or 40mm Dellorto carbs take DCOE style, made by Pirelli.
|
Carburetor rubber spacer mounts, very high quality new manufacture for 45 DCOE
|
Carburetor, Weber, 45 DCOE, new, less Alfa linkage between carbs, uses your old Solex or Weber linkage to fit
|
Clutch cable bolt, special stepped bolt that connects cable to clutch arm
|
Clutch cable, new manufacture, as original. Includes Y junction for the special bolt to pass through
|
Connector, brass for 5mm spark plug wire to distributor cap.
|
Connector, brass for 5mm spark plug wire to spark plug.
|
Cotter Pin & Bracket for 9mm strapping
|
Crankshaft seals, front and rear, new manufacture, very high quality
|
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, with unleaded fuel valve seats and valve guides. Intake bore is for 1600 GTA, can be machined for GTA Jr. or to your specifications. Specify style of valve guide desired an
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, without valve guides or valve seats, with intake bore unmachined so you can custom fit.
|
Cylinder head, twin plug, prepared for 1600 motor by Jack Beck for racing; valve seats, guides, special valves, special springs installed. Head run in on dyno. Pressure tested and ready to run.
|
Differential limited-slip assembly, complete, new manufacture, specify coarse or fine spline shafts and diameter at spline end, more robust than 2000 c.c. version, designed to fit 1300, 1600, 1750 and 2000 c.c. differential housing.
|
Differential support bushings, verify dimensions to check fit.
|
|
|