|
Engine Compartment
Air filter, NOS, specify dimensions, several are correct for this car
|
Ball joint boots, lower, large size
|
Ball joint boots, upper, medium size
|
Ball joint kit, lower. Includes both lower ball joints, matching seats, snap rings, and everything else for installation. Fits both sides of car. Specify diameter of ball.
|
Ball joint kit, upper. Includes both upper ball joints and matching seats. This kit includes springs and clips to use in the rebuild of the ball joints. This kit will do both sides of the car
|
Ball joint race, lower or upper, NOS. Specify outside diameter and diameter of the hole in the middle
|
Ball joints, lower, very high quality new manufacture, includes 2 hardened seats, specify diameter of ball and diameter of the threaded portion of the shaft.
|
Ball joints, upper, very high quality new manufacture, includes 2 hardened seats, specify diameter of ball and diameter of the threaded portion of the shaft.
|
Bearings, main, 750 only, specify standard or which oversized desired.
|
Bearings, rod, 750 only, specify standard or which oversized desired.
|
Boot for 5mm spark plug cable connection to distributor caps
|
Boot for 5mm spark plug cable to spark plug connectors.
|
Brake hose kit, racing style, for all Giulietta based cars. Includes two front hoses and one rear hose.
|
Brake hose, front, original style, new manufacture, 1356.88.005, 7/16 X 20, length of threaded portion on each end is 29/32, overall length 15 3/8. Valid for all 1900 models, G. Sprint up to chassis number 0200, and 2000 Touring.
|
Brake hose, rear, from body to differential, #1365.64.020 for Giulietta-based cars, also clutch hose for 2600 Touring. 3/8 X 24, long threaded portion is 29/32, short threaded portion is 7/16, overall length is 14 15/16. Verify these dimensions please.
|
Brake lining. NOS. Front or rear, 4 pieces per set. Specify length and width and spacing between rivets to verify fit. These are the original ones, not a re-manufacture
|
Brake wheel cylinder repair kit, front, style with two shoes per wheel, new manufacture, kit does both front wheels (4 cylinders)
|
Brake wheel cylinder repair kit, rear, specify if drum or disc brakes on front, kit includes 2 dust boots and 2 seals, and does both rear wheels. For drum brake cars only.
|
Cam followers, new manufacture from Italy, 750 Veloce only
|
Carburetor diaphragm mechanism, complete unit for a Solex 32 PAIA. These are NOS
|
Carburetor rebuild kit, Solex 32 PAIA, Giulietta 1300 only
|
Carburetor vacuum diaphragm, NOS, for Solex 32 PAIA, Giulietta 1300 only
|
Connector, brass for 5mm spark plug wire to distributor cap.
|
Connector, brass for 5mm spark plug wire to spark plug.
|
Cotter Pin & Bracket for 9mm strapping
|
Differential bolts, 8mm x 1.0mm x 17mm head, to hold gear ring onto center section. Normale models only.
|
Differential bolts, 9mm X 1.0mm X 17mm head, to hold gear ring onto center section. Veloce models only.
|
Differential limited-slip assembly, complete, new manufacture, specify coarse or fine spline shafts and diameter at spline end, more robust than 2000 c.c. version, designed to fit 1300, 1600, 1750 and 2000 c.c. differential housing.
|
Engine gasket set, very high quality gaskets, silk-screened style sealant where-ever applicable, includes crankshaft seals front and rear, perfect for either 1300 or 1600 engines. Order the appropriate head gasket separately to match this set.
|
Engine, short stroke, used 1357 cc, 80mm X 67.5mm with head, block, crank, alternator, water pump, less carbs. Used for 9000 RPM racing motor.
|
|
|