|
Engine Compartment
Crankshaft seals, front and rear, new manufacture, very high quality
|
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, with unleaded fuel valve seats and valve guides. Intake bore is for 1600 GTA, can be machined for GTA Jr. or to your specifications. Specify style of valve guide desired an
|
Cylinder head, twin plug, new manufacture from Italy of original vintage style, without valve guides or valve seats, with intake bore unmachined so you can custom fit.
|
Cylinder head, twin plug, prepared for 1600 motor by Jack Beck for racing; valve seats, guides, special valves, special springs installed. Head run in on dyno. Pressure tested and ready to run.
|
Differential limited-slip assembly, complete, new manufacture, specify coarse or fine spline shafts and diameter at spline end, more robust than 2000 c.c. version, designed to fit 1300, 1600, 1750 and 2000 c.c. differential housing.
|
Distributor points, Marelli, some cars require one set, some require two.
|
Driveshaft center support rubber, D shaped.
|
Driveshaft center support rubber, original style, one piece
|
Engine gasket set, very high quality, asbestos-free modern, high-tech materials. Silk-screened sealant pre-applied to the large gaskets - 1600 only.
|
Engine, short stroke, used 1357 cc, 80mm X 67.5mm with head, block, crank, alternator, water pump, less carbs. Used for 9000 RPM racing motor.
|
Engine, Twin-spark, 2000 cc, good used motor from a running car in Italy, includes the F.I. airflow meter, alternator, and starter.
|
Exhaust pipe and muffler, extra heavy duty, great fit, front section that hooks to the headers, the 1st muffler and a pipe out the back. For Giulia Super up to 1970, GT/GTV up to 1970, Duetto Round Tail 1600 only.
|
Fan blade, high performance, Euro style, requires less HP to turn, 6 blade, white plastic
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, FISPA, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter assembly/Fuel pressure regulator, glass bowl version, NOS, Tecnocar, specify if uses banjo fittings, or hoses with hose clamps.
|
Fuel filter element with new spring, twin carb models
|
Gas tank sending unit, OEM, specify Veglia or Jaeger, must match the gauge, specify the length of tube from mount flange to tip, modern manufacture
|
Gear, front of crankshaft, drives oil pump
|
Ground strap for battery, original wire style, covered with black sleeve, lead terminal end
|
Hand brake cable, Includes front section that attaches to hand brake handle with correct fittings on each end. Also the rear section that connects to each brake.
|
Hand brake cable, Includes front section that attaches to hand brake handle with correct fittings on each end. Also the rear section that connects to each brake.
|
Head gasket, very high quality, modern style with silk-screened sealant around the perimeter, Reinz material , 1600 c.c. engines only
|
Headers for exhaust, tube style like the original. The flanges are heavier duty than the original, 1600 only.
|
Hose for air filter, oval, black, new manufacture
|
Hose, cowl drain. Light grey plastic hose with visible wire winding. Say that three times fast. Just like the original.
|
Master cylinder, Bonaldi, NOS
|
Muffler, center, with pipes fore and aft. For 1300, 1600 and 1750 GTV only.
|
|
Oil filter, cannister style, 155mm X 68mm, UFI brand
|
|
|